QBCC Licence 1213114 Warwick base, SW & SE QLD Mon to Fri, 7am to 4pm
(07) 4661 1116
Total Fire Protection ServiceWarwick QLD
Service tags and certification stickers on a row of freshly serviced fire extinguishers

Our services

Emergency and exit lighting testing and maintenance

When the power fails, exit and emergency lighting is what gets people out.

Tested to the standard, logged properly

Emergency and exit lighting has to hold its charge for the full duration and be inspected on a set schedule. We run the discharge test, check every fitting and record it, so a failed battery or a dead fitting is found by us, not by an auditor.

  • Inspection and maintenance to AS 2293.2
  • Discharge testing of every fitting
  • Repairs and replacement of failed units
  • Findings issued in a written report
What we test EXIT 0 min 90 min DISCHARGE TEST

The test that actually proves the fitting works

An exit sign that lights up on mains power tells you almost nothing. What matters is whether the battery behind it still holds for the full duration once the power drops out.

We run the discharge test on every fitting, check the ones that fade early, and issue the results in writing. A dead battery gets found by us, on a scheduled visit, rather than by an auditor or in an actual evacuation.

  • Inspection and maintenance to AS 2293.2
  • Discharge testing on every fitting, not a sample
  • Written report covering pass, fail and replacement

How an exit lighting service runs

Book the visit

Tell us the building and roughly how many fittings. We work around trading hours where the test needs the power down.

Every fitting checked

We test each exit and emergency fitting through its full discharge, not just a spot check.

Repairs and replacements

Failed batteries and dead fittings are repaired or replaced so the building is left compliant.

Report in writing

You get the results on paper, logged against the building and scheduled for next time.

Common questions

Questions we
get asked

If yours is not here, ask us on the phone. We would rather answer it before you book than after.

What does AS 2293.2 actually require?

AS 2293.2 covers the inspection and maintenance of emergency and exit lighting in existing buildings. In practice it means each fitting has to be tested through its full discharge duration on a set schedule, and the results have to be recorded. Both halves matter: an untested fitting and an untested-but-unrecorded fitting are the same thing to an auditor.

How long does emergency lighting have to stay on?

The fitting has to hold its rated duration once mains power is lost, which is what the discharge test measures. Batteries lose capacity as they age, so a fitting that passed comfortably a few years ago can fall short well before it looks like it has failed.

Will you need to turn the power off?

The discharge test needs the fittings to run off their batteries, so part of the visit involves dropping power to the circuit. We schedule it around your trading or operating hours so it is as little disruption as possible.

Can this be done at the same time as our extinguisher service?

Yes, and it usually should be. Because we handle extinguishers, alarms and evacuation plans too, the exit lighting is checked on the same visit and lands in the same asset register, on the same schedule.

Related

Other services we provide

Most buildings need more than one of these. Handled together, they sit on one schedule and one register.

Get your emergency & exit lighting sorted.

Warwick based, servicing South West and South East Queensland. QBCC licensed, FPA Australia Bronze Member.